(800) 853-2651
SHOP NOW

Farmall 100 shifter photo

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

N

NICK D

Member
I am rebuilding my Farmall 100 transmission and have the top cover with the shifter rails disassembled. Is the bend in the shifter supposed to be there. The shifter rod on my Super AV is shorter and does not have a bend. I was going to straighten it on a press, but wanted to check first. I welded the tip of the shaft to take up the excessive slop. The rebuild continues....
v6930.jpg
 
Just had a look at the 130 shifter and it's straight, no bend.

How are your drawbar studs and threads on the final drives? I'm going to have to heli-coil a couple of mine it looks like.
 
The threads on a couple of the studs are a little banged up. I might try to run a die over them to clean them up. I ran a tap thru the holes without studs and they don't seem too bad. I think they will hold a bolt fine. Thanks for looking at the shifter for me. Good luck with your final drives.
 
If you need any parts for your 100 i have them, i parted one out, and i have to verify again but i think the shifter is bent on it like yours, ill check again.


Andrew
 
Dave: I believe you are correct, my SA, 130 and 140 have straight shift lever. I looked at two 100s last week and both had that bend in the lever.
 
You must log in or register to reply here.

Similar threads

crsutton81
Ashley W.....Farmall 100 / 140 front leveling rod
Replies
7
Views
411
crsutton81
crsutton81
A
Update on Farmall C with gear shifter not moving into 3r
Replies
6
Views
559
Steve@Advance
S
P
1955 Farmall 100 Engine Overhaul
2
Replies
38
Views
3K
BarnyardEngineering
BarnyardEngineering
5
Farmall 100 Fast Hitch Diagonal Link
Replies
2
Views
227
couv
C
D
Farmall 560 pops out of 4th gear under load.
Replies
6
Views
952
ss55
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top