IH 2point blade

460/560 · Apr 13, 2009

I have a model 200 8 foot blade that is froze up. I got it to move a little by putting some heat on it and pulling with a come-along, but it is still really stiff. Is there a way to disassemble the center pivot without cutting it? I"d like to take it apart and clean it up good and fix a few other things, and was just wondering if there was an easier way that I"m not seeing. Thanks

Al L. in Wisc. · Apr 13, 2009

Gots me an eight footer also and my 210 pounds wouldn't hardly get it to move. It is at a shop where they are going to remove the grease zert (may have to cut it out) heat the tube and '...the old hard grease will run out like snot.' A re-grease and it should be good. Hope my yet to get eight footer turns easy. Is yours yellow or red?

460/560 · Apr 14, 2009

Thats about what I have been trying to do to mine, but its pretty tight. Mines brown lol. I believe alot of them were white though

IH 2point blade

460/560

Member

Al L. in Wisc.

Well-known Member

460/560

Member

Similar threads