(800) 853-2651
SHOP NOW

1456 clutch

A

Anonymous-0

Well-known Member
i have a 1456 with the hyd clutch assist. i need to adjust the clutch because i just replaced it. is it normal for the assist to push the rod forward when starting the tractor? i just cant seem to get it adjusted properly. either the clutch slips cause the throw out bearing is against or i cant get it in to gear when adjusted the other way. can anyone explain to me how to adjust this clutch? and if its normal for the assist to push forward when the tractor is running? it seems to make adjusting impossible. thanks joe
 
The booster should not move upon starting engine. Even if adjusted wrong it would only move a little. Back adjustments off on both ends until linkage is free , start engine. If any movement the valve in booster is stuck or assembled incorectly. Proper adjustment starts at pedal side. Take up slack so linkage is just touching activating piston, this should give you about maybe half inch pedal movement of valve before output end starts to move. Then adjust other end to get about one eight inch clearance on release bearing to fingers. Clear as mud, right, could show you in a minute but not good at describing procedure.
 
i will try that. thanks. i will say that when i start the tractor that the rod between the booster and the clutch arm moves forward a half inch right away. do i need to replace or rebuild the booster? thanks joe
 
If it only moves half an inch and then stops, it sounds like the adjustment on the clutch pedal side is wrong, too tight, back it off until loose.
 
You must log in or register to reply here.

Similar threads

D
Farmall 300 clutch trouble
2 3 4
Replies
76
Views
1K
Mrfred54
M
C
Super C Clutch Adjustments
Replies
16
Views
344
cdd
C
G
Super A governor adjustment
Replies
5
Views
313
560Dennis
560Dennis
C
Case 300 round nose foot clutch problem
2
Replies
26
Views
856
chris142
C
U
MF 35 Clutch Problem
Replies
8
Views
282
Uncle Fred 02
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top