(800) 853-2651
SHOP NOW

A414 lift stuck in raised position

A

AussieA414

New User
I have a A414 (Australian version of the UK B414) tractor. I was using a ripper and it has got stuck in the up position and will not lower. The engine is straining when I now turn it on. What would make the 3PL stay up like that? Your help is appreciated. thanks.
 
Check the isolator valve (the knob under your right leg on the front of the hydraulic housing). It sometimes gets turned in from rubbing on your leg. If it is in, it will isolate the cylinder from the valve keeping the three point up.
This might not be the problem, but it would be the first thing I checked before digging into the valve.
 
Had 364 that developed same problem. Lift stuck in the full up position.The 364 appears to have the same hydraulics.
After check the isolator valve mentioned by BCNewf remove the plate on the top of the hydraulic unit(under seat) to inspect valves and linkages.You may have to drain some of the fluid to be able to see.
On ours the draft spool had broken where the linkage connected to it. The draft spool was in the "raise" position and therefore the lift was stuck in the up position. This maybe a common problem.I was able to find the draft spool aftermarket which was much cheaper than IH/Case dealer. Once you remove the cover and drain some to most of the fluid out you should be able to inspect the valve and linkages.
A factory service manual(worth the money) and help from this forum allowed me to replace the draft spool and all the o rings and gaskets successfully. This saved us a considerable amount of money.

good luck
BMD
 
You must log in or register to reply here.

Similar threads

B
Ford 841 lift arms stuck in raised position.
Replies
10
Views
325
Bob in Tennessee
B
M
404 finiky lift arms
Replies
0
Views
169
Moonshade
M
M
404 finiky lift arms
Replies
0
Views
175
Moonshade
M
W
link arms stuck
Replies
3
Views
437
RGMartin
R
M
Massey TO35 the lift arms vibrating
Replies
0
Views
76
mossdm
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top