farmall h pulley socket size

NewHpuller · Feb 21, 2009

what size socket do i need to remove the pulley off the crank shaft, do i also need puller for the pulley or cam gear?

Dave_Id · Feb 21, 2009

What engine?

Dave_Id · Feb 21, 2009

Sorry, I didn't read the title.

NewHpuller · Feb 21, 2009

1944 farmall h

Nebraska Kirk · Feb 21, 2009

I am not sure of the nut size, since I don't have a socket big enough, I have always used a pipe wrench or cresent wrench. You may not need a puller for the pulley, all the ones I have messed with came off by pulling by hand and with a pry bar between the engine and pulley. I don't know why you would need to remove the cam gear unless it is bad, but remove the two bolts that hold the cam in, they can be reached through the holes in the cam gear, then remove the cam. I would be leery of using a gear puller on the cam gear, you could break the thin webs, I would use a press so that you can support the gear nearest the middle and press the cam out of the gear.

Anonymous-0 · Feb 22, 2009

The nut is 1-11/16".

farmall h pulley socket size

NewHpuller

Member

Dave_Id

Well-known Member

Dave_Id

Well-known Member

NewHpuller

Member

Nebraska Kirk

Well-known Member

Anonymous-0

Well-known Member

Similar threads