Building a custom planter using parts I have on hand.I was looking for a picture that shows how the A-201 is mounted. My plan is to mount it to the drawbar and use rear rockshaft to lift.Saw a picture a while back that looked like the drawbar was flipped forward , but the picture wasn't clear.A picture or even a good discription would be helpful. Thanks Dan
- Thread starter DWarack
- Start date
Anonymous-0
Well-known Member
You will need the drawbar moved in the forward position so the hitch of the planter will be forward enough to let the rockshaft lift. I would mount on the front so the rockshaft could raise and lower better. Ifn ya need some drive stuff that is powered off the axles i have some different types.
Rollie NE PA
Well-known Member
I took some pictures from my manual with my cell phone. They are not to clear but hope they help.
Rollie
Checked pics. after posting them and they don't look to good. If you can't view them with enough clarity let me know and I will try a regular camera.
As Gene said you have to reverse the draw bar and face it to the front of the tractor. When the planter is fastened to the draw bar, there are little dogs that are on the planter that keeps it from swinging side to side.
Rollie
Checked pics. after posting them and they don't look to good. If you can't view them with enough clarity let me know and I will try a regular camera.
As Gene said you have to reverse the draw bar and face it to the front of the tractor. When the planter is fastened to the draw bar, there are little dogs that are on the planter that keeps it from swinging side to side.
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy