Torque amplifier Tool

TWL · Jan 31, 2009

Would anyone know where to get the tool for the spanner nut on a torque amplifier.Models like 460,560.Would it be a socket similar to the older 4x4 truck spindles.Thanks for any advise.

the tractor vet · Jan 31, 2009

I have one and only one and it does not leave my sight . Sorry . That another one of the things that i should start having made and selling .

D Slater · Feb 1, 2009

Yes the end that goes in the nut is similar to the 4 wheel ones. I made one a long time ago from a short piece of 3.5 tubing 3/16 or 1/4 wall, can't remember. Notched the end to fit nut, helps to have a nut off for pattern. Welded plate on other end and made a 1/2 inch square hole in middle of plate. It has held up pretty good but just last year I welded a piece of old 1/2 drive impact socket in plate because the 1/2 hole in plate was rounding out. I find a lot of nuts have had the hammer and chisel treatment and the slots in nut are damaged. Could give measurements if needed.

Torque amplifier Tool

TWL

Member

the tractor vet

Well-known Member

D Slater

Well-known Member

Similar threads