Talked to him tonight and I sent him the picture you posted on your reply the other night. He is going to look at it tomorrow just to make sure we are on the same page. You had mentioned in a reply about swapping email addresses, I would like to do that just to make it a little easier to communicate. I am not sure about posting email on the site, do you have a better suggestion? You had mentioned repairing the assy that I have on the tractor right now. I thought about that myself but I am unsure about just how to do it. The assy I have now has been brazed several times. Could a new tube be welded in? I am not sure how the tube is connected to the block that is bolted to the square plate. I thought if there was enough meat to the block that I could cut off the tube, drill and tap the block to accept a fitting and just go from the block to the lift control tube with one hose and eliminate the tube altogether. Let me know your thoughts and let"s figure out how to either swap emails or talk on the phone about this. The more I think about it I had rather figure out another solution rather than depending on 45 year old used parts.
- Thread starter Joey K
- Start date
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy