(800) 853-2651
SHOP NOW

1963 Farmall 706 rod ends different from 1964

R

relaurain

Member
Bought a long tierod end from this site for a 1963 Farmall 706 but it came with a larger tapered shaft than my original.
Mine is approx. .665 tapering up to .775.
Has anyone run it to this buying parts for theirs? I would guess they had a part change for 1964 and up?
 

Or, you have an aftermarket front end, or a front end adapted from a different tractor.

Can you post a picture to confirm?
 
Here it is against the stock one.
v6457.jpg
 
IH had only two outer tie rods for row crop Farmalls from the late Super H until the 86 series. They were differant only in lenth. The taper on the end stud was the same. Are you sure you have an IHC factory front end?
 
Yup, you have a factory IH wide front, looks correct for the 706 to. The Part Number for the short one is 359984R93. Part Number for the long one is 384441R93. What is the part number on the one you have? There is a differant part number for International Wheatland models tho. Give YT a call to verify the part they sent is correct. My parts books show no change in tie rods in the 706.
 
Thanks for the posting.
YT numbers don't correspond with these numbers so I don't know what the part is for. The part was longer and had one extra notch in it but they did have the same spacing so it set in correct.
 
You must log in or register to reply here.

Similar threads

F
706 Farmall fuel cut off solenoid repair
Replies
3
Views
281
used red MN
U
C
Farmall H Horsepower upgrades
Replies
19
Views
3K
DR. EVIL
D
C
H Farmall I bought at an auction
Replies
8
Views
794
braol
B
G
Almost too embarassed to post again TSX 706
Replies
16
Views
1K
JMOR
J
S
Farmall A tie rod ball diameter
Replies
6
Views
719
riverbend
R
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top