How do I wire the lights up on my M after the conversion

tcanthonyii · Jan 4, 2009

I've run all the new wiring, the old was really bad and switch out to 12v lights. I've included a picture of my switch since I know there were several. I looked at the diagram in the manual and for the life of me cannot figure it out. It's pretty crude.

I have the standard lights on the light bar and then also a rear light with out the red light.

Thanks

T.C.

caterpillar guy · Jan 4, 2009

Just ues the same location that they where on before. Nothing changes because of the conversion.

r4etired · Jan 4, 2009

You will need to change your light bulbs to 12v. Carquest carries the 12v that will interchange with the regular farmall bulbs.

tcanthonyii · Jan 4, 2009

Don't remember where I pulled the wires off is the problem. Well I do and I don't plus they didn't work before.

I already replaced the bulbs.

T.C.

Brownie 450 · Jan 5, 2009

There was an excellent picture/ diagram of this light switch/wiring diagram in the recent issue of Red Power. There are probably diagrams in the archives. Can't send the diagram because I already took the magazine back to my brother.

tcanthonyii · Jan 5, 2009

Brownie, Thanks for reminding me. I even had that stupid page earmarked b/c I knew I would need it.

T.C.

How do I wire the lights up on my M after the conversion

tcanthonyii

Member

caterpillar guy

Well-known Member

r4etired

Member

tcanthonyii

Member

Brownie 450

Member

tcanthonyii

Member

Similar threads