Anonymous-0
Well-known Member
A 200 has a Draft Link Rod & Pipe on the right side that can be stored on a pin on the Torque Tube OR extended and pinned to the right Touch Control Rockshaft.
If I extend it and use it to adjust the angle of the tool, in certain settings, it "jumps" about an 8th of an inch constantly, and "chirps" when it "jumps".
Is there some setting I need to do ? Am I hooking it up improperly ?
If I extend it and use it to adjust the angle of the tool, in certain settings, it "jumps" about an 8th of an inch constantly, and "chirps" when it "jumps".
Is there some setting I need to do ? Am I hooking it up improperly ?