Torqing H Head

Chad504 · Dec 19, 2008

I have the I&T Manual, and I know the torque load, but what order should I torque them in?

Bob · Dec 19, 2008

Are you missing a page... I've never seen an I&T manual that didn't give the head bolt sequence.

old · Dec 19, 2008

If it does not show you the order just start in the center and work out in a circle and you will be just fine. Or you can also start in the center and do an X pattern either one works well
Hobby farm

Jonathan Mirgon · Dec 19, 2008

My I&T book for super c gives no tourque pattern either, No wiring diagrams either. Not real happy with the I&T manual myself.

Andy Motteberg · Dec 19, 2008

It should say in the book, but start from the center nut and work your way out to the others.

riverbend · Dec 19, 2008

Start in the center and work towards the ends in a spiral pattern. Bring the all nuts up to 40 ft-lbs, and then 50, 60, and finally 70 ft-lbs. Keep going around until all the nuts hold at 70 ft-lbs.

I'm guessing you know about bring the motor up to temperature and re-torqueing the head. BTW the IH manual does not show a pattern either.

Greg

Torqing H Head

Chad504

Member

Bob

Well-known Member

old

Well-known Member

Jonathan Mirgon

Member

Andy Motteberg

Well-known Member

riverbend

Well-known Member

Similar threads