(800) 853-2651
SHOP NOW

Farmall H Shutter linkage

A

Anonymous-0

Well-known Member
I am trying to restore my H as original as possible. I have purchased the shutter linkage; the crank and long rod from the crank to the lever on the front of the engine next to the oil fill section. The question: Does the long rod have a bend or an offset before it gets to the crank? I have the crank in the upper right hole in the front plate as shown in manuals. However, the crank and rod do not line up. I can force them to meet, but it does not provide for a smooth operation. Does anyone understand what I am trying to describe?
 
I am restoring a SH with shutters. It is a stage 2 with the battery under the seat and hydraulics under the tank. I also have a rod from a early SH tractor that I used for parts and that rod should be the same as your H. It has a number of slight bends with two fairly close to the crank end. What do you mean by the "front plate"? The crank bracket clamps to the steering post and the only other thing the rod passes through is a support that bolts to the fuel tank mount. Are you trying to pass the rod though one of the holes in the rear tank support?
 
You must log in or register to reply here.

Similar threads

G
Electrical problem on a H
2
Replies
30
Views
801
rustred
rustred
K
Farmall H hydraulics
Replies
13
Views
943
DeltaRed
D
D
Trying to understand cab/lights wiring connection to light switch on farmall 826 diesel
Replies
2
Views
258
used red MN
U
crsutton81
Farmall Cub fertilizer attachment
Replies
6
Views
457
crsutton81
crsutton81
D
Farmall H Crnk Ply Nut Rmvl
Replies
14
Views
481
Dieselsbest
D
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top