Just picked up the M I was given a while back. Noticed that it has a sprocket on the end of the crankshaft secured by the pin that the crank engages. Question-- do anyone know if there is a pulley that will fit on the end of the crankshaft and secured the same way. Looking for a simpler way to add live hydraulics to my M.
- Thread starter Dr. Bert
- Start date
Janicholson
Well-known Member
The short answer is no but.
Appropriate pulleys are available but need to be machined to match the shaft etc. Running a belt driven system has some limits, but works well most of the time. The belt can (and does) act like a safety clutch limiting breakage in other places (more costly breakage). Steven in AZ has posted pictures here many times so they should be in the picture archives. Good luck. JimN
Appropriate pulleys are available but need to be machined to match the shaft etc. Running a belt driven system has some limits, but works well most of the time. The belt can (and does) act like a safety clutch limiting breakage in other places (more costly breakage). Steven in AZ has posted pictures here many times so they should be in the picture archives. Good luck. JimN
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy