(800) 853-2651
SHOP NOW

Feasibility question

L

Larry in GA.

Member
I have a homemade log splitter; the cylinder is 29 inches long and 4inch diameter. Can I take the lines off the super C fast hitch remote control valve and power the log splitter from there? Would I need any additional hardware? What about fluid levels ?
 
More than likely the SC has 1-way hydraulics on the lift. The splitter is going to require power in, power out (ie: two way hydraulics). A remote valve is going to have to be installed to give two-way control.

Good luck,

Charles
 
Yes you can but there is a retarder in the line so the implement wont drop fast. It is located in the block in front of the seat bracket. Remov it and it will work. Your cycl holds more oil that the one on the fast hitch. You can add a resivour on the filler plug. They did that when putting a loader on the Cs. Now the best way would be to add new lines off the input where they go to the control you now have and then put a control valve on the splitter Just add some couplers in those lines so all you have to do is unhook them when not using the splitter and your fast hitch will work as usual. The small line is pressure and the large line is return.
 
Yes as it doesent hurt anything. It is piece of pipe around 3in dia and maybe a foot long. It has a pipe nipple welded to the bottom and a filler neck on the top. It just screws into the filler plug on the res tank. You could use anything that holds maybe 2qt of fluid. You could mount a tank any where close and use a hose running to the filler neck. Just as long as you had an opening on the top to add fluid. It could be mounted on the lite bar as its close to the res.
 
You must log in or register to reply here.

Similar threads

K
Ford 800/900 Hydraulic Remote - Auxiliary Port
Replies
8
Views
689
KJMClark
K
B
Used Homemade Log Splitter Help
Replies
9
Views
3K
WI Dan
WI Dan
J
Cockshutt 550 3PH not working
Replies
13
Views
714
JohnnyUnknown
J
A
IH460U dripping hydro fluid from steering valve
Replies
3
Views
262
AC_IH_MF
A
T
Case-IH 895 steering question.
Replies
15
Views
441
Texasmark
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top