(800) 853-2651
SHOP NOW

Question For Tractor Vet

R

Red Mist

Well-known Member
Tractor Vet:
I am in the process of a clutch job on my 1953 Super M. With regard to resurfacing the flywheel, didn't you say the relationship between the two surfaces should be 1.406 inches?
Thanks.
mike
 
Sounds like you two are pretty knowledgeable when it comes to clutches. The clutch in my H seems to engage almost immediately when you begin to let off the pedal. Is this something I can adjust or am I going to have to start replacing things in there?

I've had it apart for other reasons before, but don't know much about my options in this case.
 
(quoted from post at 15:25:57 10/30/08) Sounds like you two are pretty knowledgeable when it comes to clutches. The clutch in my H seems to engage almost immediately when you begin to let off the pedal. Is this something I can adjust or am I going to have to start replacing things in there?

I've had it apart for other reasons before, but don't know much about my options in this case.
Click to expand...
Eric: I am not an H expert on clutches, but the rod from the pedal to the fulcrum is adjustable. Did you check it? Also, there should be 1 + 1/8 inches of free play before you start feeling pressure as you depress the clutch. Measure off the front of the deck. This is a critical measurement. Hope this helps. mike
 
You must log in or register to reply here.

Similar threads

Ellis Kinney
Question for Tractor Vet
Replies
9
Views
321
Janicholson
Janicholson
R
Clutch throwout movement
Replies
9
Views
545
Janicholson
Janicholson
B
Radiator Empty and Tractor Surging for Super C
Replies
4
Views
226
Bookman
B
B
JD 720 Gas Compression test
Replies
12
Views
470
BMAN in Detroit
B
M
Tractor decal help.
Replies
10
Views
383
Masseyharrisnut
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top