Anonymous-0
Well-known Member
I have a battery under the seat SH. It's been a long time since I took it apart. The pivot for the seat shows the rod, 352616R1, with two of the rubber bushings and 2 washers, 352650R1. Problem is it shows the washers inside of the bushings which makes no sense. The washers look quite small in the diagram also. Parts book is TC-49 rev. 2 11-59). The only wahsers that I have that I don't have a home for are are about 21/32" ID x 1 1/2" OD and quite thin. If I install them outside of the rubber bushings the ID is large enough for the rod to pass through so the washers would only be putting pressure on the rubber bushings. Make sense? Whats up here?