(800) 853-2651
SHOP NOW

H drawbar (again)

W

WI Dave

Member
What's the distance (on an H) from the ground to the drawbar when the swinging drawbar is attached? TIA
 
Drawbar height is adjustable with the diagonal support rods at the sides of the loop drawbar...notice the many holes where the support is bolted to the drawbar.
 
Drawbar height can be adjusted with the swinging drawbar attached? With one end bolted to the tractor, I didn't think it would be adjustable.
 
The pin that the drawbar swings on doesn't fit tightly and it is quite a ways ahead so a change in height doesn't affect it very much.
 
Can't answer your question with one answer. Tire size makes a difference. Early H tractors used a angle that drawbar attaches to below axle about 1 inch longer than later ones, drawbar brace was longer also so depends which you have. Axle clamps could be turned up or down to change height and as already pointed out the braces could be moved to a different hole, 4 holes on early drawbars and five adjustment holes on later ones.
 
that's why the hole in the front of the swinging drawbar is way bigger than the pin that holds it in place, so it has room to pivot up and down.
 
You must log in or register to reply here.

Similar threads

Gambles
440 drawbar parts wanted
Replies
4
Views
802
Gambles
Gambles
R
Installing a Swinging Drawbar on 8n
Replies
9
Views
663
JMOR
J
M
Farmall 130 for plowing garden
Replies
2
Views
478
Massey_165
M
D
Farmall B - plow (bracket?)
Replies
9
Views
493
DoubleJFarmsWA
D
J
WD Snap Coupler/Drawbar release
Replies
1
Views
307
thdrduck
T
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top