(800) 853-2651
SHOP NOW

504 gas engine

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

A

Anonymous-0

Well-known Member
I understand that the gas engine in a farmall model 504 does not have cylinder sleeves. Is this much of a problem or can a machine shop install sleeves if needed?
I am interested in buy one of these models.
This particular tractor runs very well, with low hours,but I don't know at this time if the meter works. What do you guys think

Thanks
 
I suppose sleeves could be installed, not sure on that. Generally the cylinders are just bored oversive like an auto engine. Standard oversize rebuild kits are available.
 
Those just get bored out and put oversize pistons in like an automotive engine. Should be able to get pistons in .010" .020" and .030" oversized...
 
Find your pistons BEFORE you have it bored. O/S pistons are NLA from IH. I was unable to find any in the aftermarket either.
 
A freind of mine had his C153 rebuilt a few years ago. I need to check and see where they guy that rebuilt it got his parts.
He did a good job btw
 
J Emery: The only good 504 gas engine is the one you don't buy. If I were buying a 504 gasser, I would pay and treat it as though I bought a tractor without an engine. I'd run it until the engine died, or I couldn't tolerate it, then I'd find a good sleeved C-169 or C-175 from a 300 or 350.
 
You must log in or register to reply here.

Similar threads

T
farmall 504, d188 engine sleeve question.
Replies
3
Views
325
terryz
T
K
504 Electrical Problem???
Replies
3
Views
217
Kelly in tx
K
M
504 Potential
Replies
11
Views
788
militiaman11
M
S
Farmall 656 Gas Engine Options
Replies
10
Views
1K
Jhn
J
D
Repairing glow plug/starter switch wiring farmall 504
Replies
18
Views
590
BarnyardEngineering
BarnyardEngineering
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top