Md Engine Sleeve And Piston Removal

Anonymous-0 · Aug 25, 2008

Been Along Time Since I Had One Of These Apart But I Have A Farmall M Diesel That Broke A Sleeve Some Is In Oil Pan Some Is In Block To Pull Piston Disconnect From The Rod From Crankshaft Then I Can Remove Piston And Rod From Top Correct? Or Something Different
Thanks For All The Help
Also Looking For MD 4" Thin Wall Sleeve And Piston Part #264320R3

El Toro · Aug 25, 2008

You will need to pull the head too. You will need a sleeve puller to pull the sleeves. You probably will need a ridge reamer so the rings will clear the top of the sleeves. You probably need to check that block bore on the sleeve that broke. Probably wasn't tight enough in the block.
Just remove the rod nuts and cap and you should be able to drive out the rod and piston. Use a piece of 2X2 oak and a big hammer. Hal

glennster · Aug 25, 2008

try these guys for the sleeve and piston. they have a lot of nos stuff for i-h
CLYDE BERKSHIRE
BERKSHIRE IMPLEMENT CO INC
P O BOX 237 US 35 NORTH
ROYAL CENTER IN 46978
PHONE 574-643-3115
New IH Parts - 40 Years of parts available.

Md Engine Sleeve And Piston Removal

Anonymous-0

Well-known Member

El Toro

Well-known Member

glennster

Well-known Member

Similar threads