(800) 853-2651
SHOP NOW

1466 pto

C

cobra1379

Member
I recently replaced the spider gears in our 1466. It went back together great but now the pto wont work. I'm thinking some oil passage may be clogged but cant seem to find it. Any ideas??
 
Well there is no hyd. passages for the PTO from the main Hyd. system as the PTO has it's owen pump . SOOOooo my guess is (1) ya banged the pickup tube on the PTO when ya either removed it or when ya put it back in and now it lost it's seal or (2) the tiny little pin in the PTO valve stem has broken and this is now working the valve and thus the PTO will not work . SO be fore ya drain out all the oil and pull the PTo unit first remove the valveout the bottom as tis is the only way that the WHOLE valve will come out and see if you have one long valve or a two pice valve if the latter then the pin is broke and you will need to pay a visit to your friendly Case I H store and get a new pin and a couple O/Rings . Then ya need the special test fitting to hook up a gauge that will read 600 lbs. and set the pressure at 265 and lock the top nut and your good to go. Now if the valve is NOT the problem then time to pull the unit and see if ya banged the pick up tube and it is loose in it's bracket and repair and replace the seal.
 
You must log in or register to reply here.

Similar threads

T
Weak PTO on IH 300 Utility
Replies
4
Views
238
MARK ROBKE
M
S
Ford 5000 SOS no fwd or reverse
Replies
4
Views
292
Bern
B
P
Farmall M PTO install
Replies
5
Views
286
glennster
glennster
L
Super A Oil Pressure
2 3
Replies
48
Views
2K
kshansen
K
F
Bolens G192 / Iseki TS1910 PTO differences
Replies
1
Views
264
fordmaneddie
F
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top