Joe Nyenbrink
New User
I have a super M pulling tractor and I was told you could get plastic fenders for it to reduce weight. If someone could give me the source these that would be appreciated.
- Thread starter Joe Nyenbrink
- Start date
rustyfarmall
Well-known Member
No fenders at all will weigh even less.
Anonymous-0
Well-known Member
put a lighter driver on the seat
Joe Nyenbrink
New User
I have been pulling without fenders and now some pulls in the state of Michigan require fenders or you can not pull. So I need a source for plastic or aluminum to make the 5500 lbs class.
Janicholson
Well-known Member
Use a holesaw and drill about fifty holes in the flats of the finders you have.
Use shrink wrap. or boxing tape to cover the holes. (stronger than a hand made fiber part)
(I assume the belly pump, PTO, Belt Pulley drive, Drawbar front mount, Generator, and other items have been whittled down or removed!)
Compact spare tires on remade hubs can also remove dramatic Weight. JimN
Use shrink wrap. or boxing tape to cover the holes. (stronger than a hand made fiber part)
(I assume the belly pump, PTO, Belt Pulley drive, Drawbar front mount, Generator, and other items have been whittled down or removed!)
Compact spare tires on remade hubs can also remove dramatic Weight. JimN
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy