Belly pump on H

Pairodox · Aug 10, 2008

I've noticed that my belly pump is leaking. From the bottom if you look at the thing while on your back ... and from the 'front' if you look at the thing from the observation port. Are there gaskets that need to be replaced here? I'm guessing I need to remove the entire pump. Is that hard? If I disconnect the hydraulic drive shaft and (3) supply lines do I then simply remove the bolts on the bottom? Can't be that simple.

NDS · Aug 10, 2008

Yep it is simple but be carefull it is VERY HEAVY.

John - OH · Aug 10, 2008

Leaking seals or seals. Quick easy fix.

GeneMO · Aug 10, 2008

Floor Jack really helps, some use threaded rods to lower it down, but that would seem to take forever.

Look in archives, thousands of posts regarding this subject.

Gene

kenindiana · Aug 11, 2008

not a bad job to do , VEERRY HEAVY!!!!!!!
use a floor jack and blocks and an extra set of hands to help guide it down and back up

kenindiana · Aug 11, 2008

not a bad job to do , VEERRY HEAVY!!!!!!!
use a floor jack and blocks and an extra set of hands to help guide it down and back up

Cub n M in OR · Aug 11, 2008

I just pulled the belly pump out of my M. I used the threaded rod trick. it worked fine, but it was slow. If I do it again, I will still use the threaded rod for stability, then just put some blocks under it while taking out the last two bolts, then pull the blocks, and lower it by hand, it was heavy, but not so bad I wouldn't feel comfortable lowering it by hand. Your results may vary.

Ben

neblinc · Aug 11, 2008

Lots of pics of my teardown on this link.

BellyPump

Randy

Belly pump on H

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

Pairodox

Member

NDS

Member

John - OH

Member

GeneMO

Well-known Member

kenindiana

Member

kenindiana

Member

Cub n M in OR

Member

neblinc

Member

Similar threads