(800) 853-2651
SHOP NOW

454 shifter problem - Hey Tractor Vet

A

andyt(pa)

Member
Broke the ARM ASSY, range shift outer front. Shaft broke just inside the o-ring in the transmission housing. How does this come out and a new one go back in?
R/
And
 
Hi Any, from archives:
Broken Shifter Lever:
Hi Irving, i have changed many of those parts, at the Case-IH dealer, where I have worked for. You can remove the lever and replace it by the left side of the rear transmission. Just drain the oil, remove the MCV control valve (the plate that hold the hydraulic pump and filter) With a short 7/8 open wrench, loosen the sealed nut, remove the broken shaft and replace the new one. It has a big spline for the timing. Just align the short lever with the fork.
This was from Bernard le mécano Québec Canada who used to post on this board. Haven't seen him for sometime on here but he was very knowledgeable on 74 series tractors.

JimB
 
Removed plate with pump and filter just like Bernard le mecano Quebec Canada and JIMB2 described, (has about 5 hydraulic lines needed to be disconnected, 10 bolts, and remove fork for pto engagement for info purposes) . Having problem removing 7/8 inch nut from broken shaft, cut a wrench to fit in housing but can not get enough torque or room to hammer to remove.
Any tricks to this.
R/
Andy
 
You must log in or register to reply here.

Similar threads

D
806 Shifter Shaft hi/low
Replies
10
Views
930
caterpillar guy
C
D
Pto shifter stop replaced, now the assembly wont reseat
Replies
1
Views
130
mhb@ufe
M
L
674 broken trans shifter??
Replies
7
Views
621
Lynn Patrick
L
J
4020 PTO Countershaft idler pin snapped
Replies
14
Views
565
tim s
T
A
case 831c case-o-matic
Replies
3
Views
247
mEl
mEl
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top