One more question on F-20 timing and spark advance

Tom Fleming

Well-known Member
Thanks for the replies. I do have one more question on the timing and advance.

At full throttle and full advance with no load, there is an occasional "miss", and pop. When I am at full throttle, and at about 3/4 advance, the engine purrs like a kitten. I have not been able to do a load test at full advance yet to see if the engine smooths out under load.

I have the timing set so that the center of the rotor is pointed at number 1 on the cap for TDC. However, there are "leads" on the rotor. At TDC should the timing be set to the beginning of the rotor contact, or to the center of the rotor contact. Just to clarify, the brass contact on the rotor as you know is a "T", so do I set the timing for the center, or the beginning of the lead. I know we are only talking 1 bolt hole on the coupler, but that can make a difference when trying to get full power.

I am also debating on the gasoline. I run 89 octane in all my vehicles, so I just fill my gas can with that when I fill up my truck. Should I be running 87 in this or is the 89 ok, or am I splitting hairs.
 
Tom,
We always set ours at the center of the "T" seemed to be the
easiest starting. When we were pulling we advanced it enough
you had to pull it to start so you didn't break an arm cranking.
Also used isopropyl alcohol in the air cleaner cup(some times ice
cubes) to cool the air. A little model airplane fuel(nitromethane)
and 105 octane av gas in the reserve tank, open the load screw
until there is a little black smoke, then close it a bit. Like to have
the engine up to temp=180* and condensation or even" lite
frost" on the intake, no muffler but enough pipe to get fumes
over your head
 

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top