(800) 853-2651
SHOP NOW

Radiator Farmall M

Our Phone System is Down!

Please use the Contact us Form

We are working to resolve the issue ASAP! Thanks for your patience!

C

CHIEFEAVES

Member
I am in the process of re-assembling the 1939 M and I have put new studs and springs on the radiator. However, the radiator seems to lean toward the front at the top which leaves space between the grill and hood. I do not see where any support rods can be attached to the top of the radiator. Any suggestions would be appreciated.
Harley
 
I have just used the top radiator hose as a way to adjust the distance between the hood and grill. Get the radiator where you want it and clamp the hose down so it will not move. I suggest you fit everything before you put fluid into the radiator, it saves much headaches. Good Luck.
 
If i remember correctly, there is a rod that goes from the radiator to the steering support bracket. I used a piece of allthread on my Super M
 
There should be a bracket at the top of the radiator for a rod to mount to. This rod reaches back to the steering shaft support casting and is adjusted at that end. Call Steel Wheel Ranch. Mike got me one for my Super M. Should be able to get the bracket if you're missing that also.

Chris B.
 
NO rod from steering support to rad on a 39 unless it has been changed. The rod came at about SN 24xxx or something like that. The 39 should have a U shaped bracket made of 1/4 x1 1/4 approx. flat iron that bolts to the rad on each side and to the front of the thermostat housing
 
Thanks for the information. There are two holes at the top of radiator and a place in the top inlet to the engine to put some type anchor bolt.
Harley
 
You must log in or register to reply here.

Similar threads

M
  • Question
Farmall M water pump leaks
Replies
3
Views
256
Janicholson
Janicholson
B
1946 FARMALL MODEL A RADIATOR
Replies
9
Views
451
gene bender
G
F
Super M Brakes
Replies
6
Views
393
farmallphred
F
S
Farmall Super M Dimensions & Measurements
Replies
2
Views
230
ScaleModelDesign
S
D
Farmall m paint
Replies
5
Views
395
gene bender
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top