(800) 853-2651
SHOP NOW

Nason Paint for 54 Farmalls

G

GordoSD

Well-known Member
Anyone have the paint code for Nason Fulthane 2K Uerethane for the 54 Farmalls?
Anyone used it? If so did you apply the ful-seal select sealer before application?

Gordo
 
I have this Dupont paint code 96766 for Farmalls.
Take a look at the paint chip it may be the same number for their Nason paint. Hal
 
El Toro is correct. I assume you have read the P-sheets off the DuPont web site. Best to do what they say. However, most quality urethanes do not require a sealer over their own products. For some reason they were having bleed through. I have not used it, only mentioning what I have read.
 
Just remembered something. In 1954, IH was using 1102b, not 2150 which is 96766. I do not know the DuPont code for 1102b, or if it even exists. Best to ask your DuPont dealer. Otherwise use DuPont 7410 (IH 50, until mid 1949), or 96766.
 
Thanks for the info guys. I did read all the tech sheets. I'll use the sealer as I primed and blocked the tin about 4 times. There could be some thick surfacer where the low spots were. I used 2150 with hardener on all the cast, the wheels, frame engine etc. But I want to go urethane on all the tin and fenders. Hope the 96766 will match. Will get some photos of this "MikeCA Porsche Paint Job". I spent more time on this tin than I did on a 56 TBird! 12 holes in the fenders, and another 6 in the lightbar, two in the PTO shield! The tractor is half bronze!
Need to get that SMTA finished by 8 June for some baling chores. And a soft water wash system on the well for cleanup after.

Gordo
 
You must log in or register to reply here.

Similar threads

L
Buffing/Clearing IH 2150 or John Deere Green
Replies
1
Views
845
Stephen Newell
S
F
JOHN DEERE 6030 2 PACK PAINT CODES
Replies
0
Views
221
fivesix
F
A
Martin Senour Paint codes discontinued??
Replies
3
Views
348
DoubleO7
DoubleO7
M
short block for a fordson dexta
Replies
8
Views
341
Melshel
M
L
Farmall Super H Decal Question
Replies
6
Views
328
pat in wis
P
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top