(800) 853-2651
SHOP NOW

Needing help with Super C's transmission

A

Adtrailers

New User
While driving our Super C out of the field today, I was shifting from 3rd to 4th, and something broke. The tractor would not move. The left axle would not engage. We could get the tractor to drive by pressing the left brake, which caused the gears to drive as if the tractor was turning left.

Can anyone give me some suggestions before I start digging into it?

Thanks,
Adtrailers
 
If it will move with the brake on it about has to be broken past the bull pinion, and about all that leaves is the bull gear or an axle.
 
I have posted to this type of question before. It is almost 100% certain to be a broken axle on the left side. I have done this repair several times. It isn't really hard, just time consuming, and parts are a little heavy, especially if your tires are loaded. You need to block up the tractor really well, take off the tire and wheel, then remove the axle retainer form inside the transmission housing.The last one I did through the PTO opening, but I wouldn't recommend that if you have big hands, or if the axle is held in by a snap ring, rather than a plate with two bolts. It is worth a try, as otherwise you will spend half a day removing the deck and all associated parts. After the axle is released, unbolt the axle housing, remove the bearing retainers from it, then press, beat, or otherwise abuse the axle until it comes out of the housing. The axle presses toward the outside, leaving the inner bearing in the housing, and bringing the outer bearing with it. You may find that it is a good time to replace axle bearings, and almost certainly the seals.

Post back if you need more help.
 
It will be more work but i would pull the tranny top off so ya can get to the parts easier. This will allow ya to inspect the right side as you know the tractor is 50 pluss yrs old and hard to tell what else is bad.
 
You must log in or register to reply here.

Similar threads

D
Rear mount sickle mower for Super C w/ mid mount belly mower
Replies
6
Views
486
gene bender
G
J
Oliver (Cockshutt) 1365 4wd
Replies
10
Views
785
rrlund
R
J
IH Super C engine help
Replies
15
Views
679
jaburford
J
J
Trouble with loader hydraulic valve
Replies
5
Views
287
Brown David
Brown David
E
IH 3414 Hydro Help
Replies
3
Views
497
Mike(NEOhio)
M
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top