1950 cub re-wire

walterd · Mar 29, 2009

I have looked at Bob M's wiring diagrams and still can't find what I need. My cub is 6 volt with a voltage reg. a three position switch, on/of switch/ fuse holder, generator and a MAGNETO. Thanks guys

Janicholson · Mar 29, 2009

The magneto is not at all connected to the other parts of the electrical system. It gets no voltage at all. A single wire from the side of the mag goes to the Push Pull switch. This switch is a grounded body switch. Thus the switch grounds the mag, shutting off the tractor. A ll other parts of Bob's diagram will work. Lights and starter, and charging system. Use a combination of #2 and #4 diagrams. At the amp meter there may be a wire connected directly to the fuse this will replace the wire from the L terminal on the VR (some had no L terminal and were wired that way). There will be no wire going to the ignition sw, as on yours it has no wire to supply it. Note in #4 the only part you need is the Mag wiring. JimN

walterd · Mar 29, 2009

Thank you so much

1950 cub re-wire

walterd

New User

Janicholson

Well-known Member

walterd

New User

Similar threads