(800) 853-2651
SHOP NOW

Axle bearing removal on 130

E

EZ

Member
Hi all,
The bull gear axles have a bearing and a seal retainer on them. I have to remove the bearings to swap out the seals. The bearings are good, I don"t want to damage them.
What is the best method of removal. There is not alot of space between the retainer and the bearing. This is on my 130 final drives.
 
When you remove the covers (or seed plate drive) and the bolt and washer the axles should bump out through the bearings. Remove the pans and catch the bull gears and watch for spacers and keep them in the right order. Also, mark the gears, they only go one way.
 
You must log in or register to reply here.

Similar threads

F
Ford 861 rear axle bearing replacement
Replies
7
Views
382
Dean
D
C
Deere 530 clutch bearing retainer removal
Replies
1
Views
284
MSD
M
M
Super A wheel axle retention
Replies
1
Views
370
Jim Becker
J
J
unstyled JDA cam shaft removal
Replies
7
Views
344
Mark-Ia
M
D
Ferguson axle removal and seal repl
Replies
4
Views
381
Hobo,NC
Hobo,NC
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top