(800) 853-2651
SHOP NOW

3588 PARK and pawl

K

kidd1954

Member
I have a 3588 on the flat the park engages fine but with any sort of resistance against it (Like on a hill) the pawl will not hold it just sounds like a rachet (pawl in and out of teeth). I have the top plate off and the gear looks good no missing teeth and the pawl looks a little rounded at the bottom point but notheing major. Is it just a linkage problem? I tried to ajust the linkage so the pawl shaft would go as low as it could into the housing but when I did that the over center piece didn't come back far enough when I took the park lever out of park to neutral.
I hope this makes some sort of sence to someone. HELP
 
A 3588 should have the spring loaded park lock not a over center one . Now ya may want to look into this as on the 88 series i am not the expert. But i am sure that after the 66 series they went with the spring loaded from the over center and when i have to pull the range cove off even a 706 it gets changed to the spring loaded one .
 
The pawl is spring loaded I call the linkage on top of the speed transmission over center linkage it may not be called that
 
As long as the linkage isn't bent or wore the other thing I'd check is if that triangle overcenter piece is on the right way. Out is molded into one side of this part. Make sure that faces away from the trans.
 
You must log in or register to reply here.

Similar threads

R
4020 park cable
Replies
2
Views
400
Richard55
R
N
Brake Pawl sizes
Replies
1
Views
221
deanostoybox
D
K
3594 park pawl
Replies
2
Views
358
Eagle Doc
E
K
DC Shutter Linkage
Replies
11
Views
589
ShakerPrairie
S
B
4240 powershift up date.
Replies
6
Views
557
used red MN
U
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top