(800) 853-2651
SHOP NOW

C seat mount/pivot

S

SDE

Well-known Member
I removed the seat support arm. Someone had removed the original bushing at the pivot point and put two nuts in its place and then put the 1/2 bolt back in. The nuts are now wore out. The bore is 1.00 in the center and 1.125 at the sides.
Was the original bushing a rubber coated steel bushing? Are these bushings made of steel or some other material?
Thank you Steve
v6800.jpg
 
This came info out of the parts book for a "C". Hope it helps.


22 2 361140R1 BUSHING, RUBBER BUSHING, seat support pivot rod, 5/8" I.D. x 1" O.D., 1-3/16" long
 
Those rubber bushings and the steel pin they sit on are available new. I see them on fleabay quite often too.
 
Steve, The other fellas who replied are correct. The bushings are available from CaseIH, They are a rubber bushing that is tapered. When installing,I put some soapy water n the outside of the bushing as they are a very tight fit.
 
Thank you everyone. I did not know what it needed because it was obviously not stock anymore.
SDE
 
You must log in or register to reply here.

Similar threads

S
Lubing The 885's Front Axle Pivot Pin
Replies
3
Views
196
ScottNC
S
E
Mf202 axle pivot shaft
Replies
12
Views
518
Eazycheeze
E
O
Wear on Front axle pivot
Replies
11
Views
881
onetotaltoolman
O
stevieb49829
Calling a machinist (or 2)
2
Replies
23
Views
3K
DoubleO7
DoubleO7
stevieb49829
Progress on the 101 Jr front rebuild-this is LONG
Replies
5
Views
548
Stan Coryell
S
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top