Author	[Modern View]
Gerald E Ackerman, Sr. 01-21-2013 13:30:39 67.142.174.25 Report to Moderator	Case upgraded the installation of the pinion shaft with the following heavier duty parts: V-202203, Washer-Thrust gear spacer (2-1/2" OD dia, 0.1345" thick) V-20217, Washer-Spring tension (0.080" thick) V-20218, Washer- Thrust (1-5/8" OD dia., 0.164"-0.170" thick) V-21042, Spacer-1st and 2nd gears (2-1/4" OD dia., 1.300"-1.306" in length) Does any one have these parts or know where to get these parts? They were included in a Spring washer and spacer kit, VTA-1649. Gerry A. [Reply]   [No Email]
1031D 01-21-2013 17:40:37 166.182.3.119 Report to Moderator	Re: CASE VA Series, Installing Pinion Shaft after #6013843 in reply to Gerald E Ackerman, Sr., 01-21-2013 13:30:39   Interesting. I have 7 VA series and never had any pinion problems. I've had chipped bull pinion teeth and trans gears though. [Reply]  [No Email]
mEl 01-22-2013 09:34:35 141.151.107.238 Report to Moderator	Re: CASE VA Series, Installing Pinion Shaft after #6013843 in reply to 1031D, 01-21-2013 17:40:37   Quoting Removed, click Modern View to see Something from my past makes me think that there was a change from the wave washer setup to a solid selective spacer setup. You need to get with a real VAC expert on this. the later 200s and clear through the 530s used a selective spacer to set the clearance bertween the bottom shaft spacers and set the rolling torque at the same time. mEl [Reply]  [No Email]