|
| |
| Case Tractors Discussion Forum |
Topic: Steering knuckles
[Return to Forum]
| Author |
[Modern View]
|
| 4430
08-12-2012 05:47:51
12.170.217.109
|
How do I remove the steering shaft on a 930 Case ?
|
|
|
| 1031D
08-13-2012 14:54:17
166.182.3.239
|
|
Re: Steering knuckles in reply to 4430, 08-12-2012 05:47:51
|
|
| There's a roll pin and key on each yoke, remove the one away from the gear box, kind of hard to get in there but a good excuse to wash the years of goo out.
|
|
|
| 4430
08-13-2012 15:47:28
12.170.217.109
|
|
Re: Steering knuckles in reply to 1031D, 08-13-2012 14:54:17
|
|
| Thanks
I was wanting to remove the front to do just that to clean it out and repaint before putting the rad and power steering back in
|
|
|
| 1031D
08-12-2012 20:46:49
107.8.251.59
|
|
Re: Steering knuckles in reply to 4430, 08-12-2012 05:47:51
|
|
| You need to remove the steering wheel, remove the pin from the u-joint in the front tub, unbolt the bearings and pull the shaft out. Then remove the steering wheel and pull the shaft out.
|
|
|
| 4430
08-13-2012 12:54:58
12.170.217.109
|
|
Re: Steering knuckles in reply to 1031D, 08-12-2012 20:46:49
|
|
| In the front knuckle down by the steering motor there's a roll pin but I can't see any on the back side of it
|
|
|
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
