|
| |
| Allis Chalmers Discussion Forum |
Topic: re: WC steering worm shaft bearing bracket
[Return to Forum]
| Author |
[Modern View]
|
| don656
09-17-2012 09:17:04
75.179.131.137
|
  I"ve been working on the steering of my 1944 WC. I have removed the steering worm shaft and plan on replacing the bearings.
The bearing bracket looks different than what is shown in the parts manual. The parts manual shows the bracket having two straight sides and only two mounting holes. As you can see in the pictures, my bracket is round and has 12 holes.
Do I have the wrong bracket or did AC make a change to the bracket?
Also, if you notice, the bearing is off center from the mounting holes, so I assume you could rotate this bracket to adjust the worm gear backlash? The service manual doesn"t mention anything about adjusting the backlash.
|
|
[Reply] [No Email] | |
| old
09-17-2012 12:05:18
209.86.226.60
|
|
| I can not say either way but I do have a WC parts tractor and it still has the steering on it
|
[Reply] [No Email] | |
[Options]
[Printer Friendly]
[Return to Forum]
[Add a Reply]
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
|
