Author	[Modern View]
Mathias NY 08-04-2012 20:03:24 69.207.112.28 Report to Moderator	I have managed to remove the spindles, but don"t really see how to remove the old bushings. They are pretty well worn, with about .100" slop in them, so there isn"t much to push against. I"m hoping there is a trick to this that I haven"t discovered yet. Thanks in advance for any tips. [Reply]   [No Email]
Dennis K (WA) 08-06-2012 10:12:06 24.21.78.195 Report to Moderator	Re: Changing spindle bushings on a B in reply to Mathias NY, 08-04-2012 20:03:24   You can buy all four bushings through ford parts on this site for about 20$ 8n / naa etc Dennis [Reply]  [No Email]
ralph1111 08-05-2012 22:23:57 204.12.181.71 Report to Moderator	Re: Changing spindle bushings on a B in reply to Mathias NY, 08-04-2012 20:03:24   The hack saw trick worked for me also fyi I rembering reading on this form some time back that the 8 N Ford bushing are the same and cheaper that is if your are working with the wishbone front end Ralph [Reply]  [No Email]
Mathias NY 08-06-2012 05:47:30 69.174.58.156 Report to Moderator	Re: Changing spindle bushings on a B in reply to ralph1111, 08-05-2012 22:23:57   Thanks for the replies. I"ll be trying the hacksaw for removal and might make myself a pilot mandrel for the installation. I do have the wishbone front end, but had planned on making my own bronze bushings rather than buying them. Depending on the cost of the 8n bushings I may reconsider my plans. [Reply]  [No Email]
Dick L 08-05-2012 09:21:07 50.51.188.202 Report to Moderator	Re: Changing spindle bushings on a B in reply to Mathias NY, 08-04-2012 20:03:24   I drove out any I rebuilt with a piece of round steel bar or a piece of pipe that was a few thousands smaller than the bearings OD. Not sure which as it has been a few years but it would have been something out of my scrap pile's. [Reply]  [No Email]
Bill Hires 08-05-2012 05:41:35 99.195.160.193 Report to Moderator	Re: Changing spindle bushings on a B in reply to Mathias NY, 08-04-2012 20:03:24   I use a Snap on Toool and recently removed this bushing from a "B" Farmall steering worm shaft. [Reply]  [No Email]
Ted in NE-OH 08-04-2012 20:31:40 98.20.254.192 Report to Moderator	Re: Changing spindle bushings on a B in reply to Mathias NY, 08-04-2012 20:03:24   Use a Sawzall with a metal cutting blade to saw a slot on them . Easy to remove after that. [Reply]  [No Email]
Hadley 08-05-2012 08:27:49 98.21.111.43 Report to Moderator	Re: Changing spindle bushings on a B in reply to Ted in NE-OH, 08-04-2012 20:31:40   I think I used a hacksaw blade (blade only not in the saw) and sliced mine right down to the limit then smacked it with a hammer and punch and it slid right out. [Reply]  [No Email]