Author [expand]	[Modern View]
Wayne Petry 02-07-2010 11:58:23 173.184.27.233 123642 Report to Moderator	Can someone tell me how to remove the rear axles to change out the seals. I have removed the axle center bolt and tried to pull the hub. No can do?? [Reply]   [Send Email]
cadet trooper 02-09-2010 16:44:14 99.139.143.189 123701 Report to Moderator	Re: AC-5020 2WD in reply to Wayne Petry, 02-07-2010 11:58:23   Wayne I'm still looking and so far can't find anything about the rear wheel hub removal even the rear brake removal says it is reccommended to remove the rear wheel and fender to help the brake drum removal. So far I've been through every page not even a picture of a rear wheel. I'll keep looking with the tenacity of a junkyard dog. I've ran into something this before just thumbing through and it shows up in a totally unrelated area.   [Reply]   [Send Email]
Wayne Petry 02-09-2010 18:13:09 173.184.27.233 123708 Report to Moderator	Re: AC-5020 2WD in reply to cadet trooper, 02-09-2010 16:44:14   I appreciate it. I can see the only way to remove the fender is to get the hub off but I don't know if the hub might come off with the axle or by itself. I have the operators manuel and it is pretty much no use. I think by the way it looks the hub should come off by itself but with heat applied and much pressure with a 3 jaw puller and an impact wrench and no budge I am afraid I will break something that shouldn't break. You know what I mean. I have begun to bend the shaft on the puller.   [Reply]   [Send Email]
cadet trooper 02-07-2010 15:16:58 99.139.149.170 123649 Report to Moderator	Re: AC-5020 2WD in reply to Wayne Petry, 02-07-2010 11:58:23   Haven't had to do that to mine I've got an IT shop manual for mine but will have to dig it up. Just looking at it I would think you can apply some heat to the hub and lots of rust breaker to get it to come off. DickL has one maybe he's got some insight on this repair.CT   [Reply]   [Send Email]
Wayne Petry 02-07-2010 16:32:33 173.184.27.233 123654 Report to Moderator	Re: AC-5020 2WD in reply to cadet trooper, 02-07-2010 15:16:58   I tried the heat and I had a 3 leg puller on it with an impact wrench. I was affraid I was doing something wrong as it wasn't even attempting to budge. I don't know. Thought maybe I am going about it all wrong.   [Reply]   [Send Email]
cadet trooper 02-08-2010 15:39:38 99.139.149.170 123680 Report to Moderator	Re: AC-5020 2WD in reply to Wayne Petry, 02-07-2010 16:32:33   I'll dig up the manual and see if the scanning gods will cooperate and try to post it if not I may need your e-mail to just send it to you but first let me see if that procedure is covered in the book.CT   [Reply]   [Send Email]
Wayne Petry 02-09-2010 07:52:22 173.185.6.226 123693 Report to Moderator	Re: AC-5020 2WD in reply to cadet trooper, 02-08-2010 15:39:38   Thanks   [Reply]   [Send Email]