Allis G Governor

Peter Campellone · Feb 16, 2009

Just purchased a new governor spring for my Allis G, put in on and now the tractor runs rough. The governor is kicking in. Can anyone tell me how to set this correctly?
Thanks ,
Peter

DickL · Feb 16, 2009

The governor should not cause it to run rough. To set it you just want the damper screw to just remove the surge. You would screw it out until it surges and then turn it in a little at a time until the surge is gone.
Running rough could be fuel or spark. Kinda have to prove one out at a time to keep from getting mixed up.

Surge damper set screw located below the governor arm in picture looking at you when you peek behind the engine cover.

JoeM(GA) · Feb 16, 2009

Peter Campellone · Feb 17, 2009

Joe,
Thanks alot, That is exactly what I needed.Will try it tomorrow night.
Thanks again,
Peter

Peter Campellone · Feb 17, 2009

Thanks joe,
Will try it tomorrow.
Peter

Allis G Governor

Peter Campellone

New User

DickL

Well-known Member

JoeM(GA)

Well-known Member

Peter Campellone

New User

Peter Campellone

New User

Similar threads