Posted by jon f mn on February 22, 2013 at 06:30:53 from (70.193.128.149):
In Reply to: Re: rod questio posted by outsidersag on February 21, 2013 at 11:01:48:
I did a 930 once, there are many things that need changing over if you are going to use the newer heads. When you bore the block you will hit the water pump a bit in the front hole. It won't cut enough to hurt water pumping, but it can walk the boring machine because it only hits on the front. If that happens you can use JB weld on the bottom cut and recut it, I know that for a fact. lol. You will need rocker arms, push rods and I remember a problem with using 2090 sleeves but I don't remember why. I used them from a 1370. The head bolts are an issue because the 30's are to long and the 70/90's are larger diameter. There will also be an extra head bolt on the newer heads, I just plugged it with a frost plug.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
