Not sure about your 3pt problem, but when you are dealing with Timkin tapered bearings you always adjust to no play and then tighten a bit to preload them. Not sure what service manual you have, or what a Case manual would say, (either a fraction of a turn tighter or a rolling torque in inch pounds or ft.lbs. To adjust the bearings you will need to pull the drawbar, drop the drawbar assy, Don't remove, Remove it totally from tractor. The leaf springs will support the assy. The complete hyd/PTO housing will have to be removed to acess the nuts on the bull gears/ end of axles. A over head, or cherry picker and a 3' peice of pipe that slides over the PTO shaft works well to remome and reinstall the housing. Tighten bearings with the big nuts, after straightening the washer tabs. Rotate each axle to check for smoth rotation, then tighten to specs. and rebend the tabs. PS you will need at least 3 5gal buckets to drain the tranny. Be sure to move the full buckets from under the tranny, before you remove the last bolt on the drawbar assy., and it rotates down on it's own. BTDT, big mess. Then reassemble. Loren
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
