Posted by Jeff B. on November 07, 2009 at 08:02:25 from (69.20.162.151):
Here is my 12 volt conversion on my Case 311. The bottom bracket is an off the shelf part. Mr Gasket # is 720-9850, but you can get non chrome ones, too. I had to use some washers & spacers on the bottom to get the pulley to line up straight. The upper bracket is similar to the one in the pic. Mr. Gasket # 865-4723. I used some old stuff I had laying around, but you can buy this stuff easily if needed. I cut it off and drilled a hole where indicated to bolt it to the front of the block. When it's all done there is almost NO adjustment. I have to hold it up, hook the belt into the pulley and then slide the bottom bolt through all the washers & spacers. Can't remember if I had to buy a longer belt or not, but I don't think so. Big green wire goes to the Amp guage, and then to the battery. One small wire loops around to the BAT terminal and the other goes to hot off of the key switch. After that, reverse the wires on the coil and add a ballast resistor if still using the 6v coil. I hope this helps some folks out there.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We've kept the same low rate for six years. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
