Spark plugs should be cleaned about every 250 hours of use. The type of plug should be changed to correspond to the kind of fuel used. A "hot" plug, one with a long distance for the heat to travel from point to gasket in the shell, is used for heavy fuel. A "cold" plug, one with a short distance for heat to travel from point to gasket in the shell, is used for gasoline.

Cleaning procedures:

• Brush or blow dirt from around the spark plug base.

• Remove the plug with a correctly fitted wrench.

• Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replaced with a hotter plug. Plug and engine manufacturers recommend specific plugs for specific uses. Even the correct style of plug will accumulate some carbon and the electrodes will scale to a certain extent. Carbon accumulation tends to allow leakage of electricity with the possibility of a complete short. Corroded or scaled points tend to weaken the spark.

• Misfit plugs should be replaced with the proper plugs.

• Clean plugs in a sandblast cleaner, if possible. If one is not available, clean with a wire brush.

• Regap the plug points. Use round gauge, and bend outside electrode to the correct gap as recommended by the manufacturer. Gap varies widely among engines, from 20/000 to about 40/000 inch. Gap specs for many models of tractors are available here..
  [Comment On This Article] - [View Other Comments]

  Discount Prices for Parts! You can help support this extensive website by purchasing your tractor parts, manuals and merchandise from our [ Antique Tractor Store ] or call our friendly sales staff toll free (800) 853-2651. [ More Info ]

  Home | Manuals | Parts | 12-Volt Kits | Carburetors | Radiators | Engine Kits | Videos | Books Know someone interested in antique tractors? Tell them about this site! Your EMail Addr Your Name Friend's Email Friend's Name Copyright © 1997-2008 Yesterday's Tractor Co. - A Washington State Corporation All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters

  About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you use antique tractors, collect antique tractors, or just enjoy looking at antique tractors, welcome to our site! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 antique tractor forums, show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.