Posted by Ralphwd45 on January 24, 2013 at 15:49:21 from (66.243.212.58):
A little over a yr ago, I bought a CA narrow front, out of a storage unit. It was only slightly stuck, and freed up easily. It was pin hitch, with all of the drawbar missing, but had a home made 3 -pt attempt, with 2--2 way cylinders, hanging off the rear, and they were plugged on one end, and plumbed for single action. After rebuilding the hand clutch, both brakes, and replacing all seals, where I removed the rear housings, I was wondering what to do with the 3 pt.I had an extra, aftermarket 3 pt, from Tonys Tractors, that I didn't need, but was made to hook to a snap coupler. I sawed the loop off the end and welded a short length of sch.40 pipe in place of it. I bought a pin to fit the hole, and put the 3 pt on, then mounted the existing cyl's and plumbed them, for double acting, to a valve that I mounted on the right fender. I ran the return hose under the tranny, and into the fill hole on the tranny, and ran my in hose to the original valve on the pump. I tied the original handle open, with a home made bracket, so it is always open. I tried using the tractor, and liked it, except it needed float on the valve, and didn't have it. Yesterday. I finally replaced the control valve, with one with float, but havent got around to starting it up and trying it. I still want to weight the front with about 200 lbs, but can;t wait to throw the 2-14 mounted on it to see what she will do! I hope it will be close to a modern hydraulic system.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
