Posted by stu (ON) on November 06, 2012 at 17:27:10 from (70.27.27.116):
In Reply to: WD45 overcenter clutch posted by Ralphwd45 on November 06, 2012 at 12:34:59:
Leonard, if you still have the original shim packs in place, examine them very closely to see the individual shims. They are very thin and become very compressed over the decades. It may require a razor to separate them.
The service manual calls for a 0.065" clearance between the clutch plates at all points around the discs. This can be measured with a drill bit as a gauge.
The manual instructs to keep the clutch engaged when not in use to keep the oil squeezed from between the plates and minimize drag when the 80W oil is cold. Since the WD45 squeezes three pairs of plates in the space that the WD had only two, it is common to find the drag with high viscosity or cold oil.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
